![]() ![]() The Ruby Console also sent many errors as follows:Ĭ:/ProgramData/SketchUp/SketchUp 2023/SketchUp/Plugins/Trnsys3d/lib/observers/AppObserver.rb:23: warning: encountered \r in middle of line, treated as a mere spaceĬ:/ProgramData/SketchUp/SketchUp 2023/SketchUp/Plugins/Trnsys3d/stdruby/fileutils.rb:93: warning: already initialized constant FileUtils::OPT_TABLEĬ:/Program Files/SketchUp/SketchUp 2023/Tools/RubyStdLib/fileutils.rb:1627: warning: previous definition of OPT_TABLE was hereĬ:/ProgramData/SketchUp/SketchUp 2023/SketchUp/Plugins/Trnsys3d/stdruby/fileutils.rb:1272: warning: already initialized constant FileUtils::Entry_::S_IF_DOORĬ:/Program Files/SketchUp/SketchUp 2023/Tools/RubyStdLib/fileutils.rb:1284: warning: previous definition of S_IF_DOOR was hereĬ:/ProgramData/SketchUp/SketchUp 2023/SketchUp/Plugins/Trnsys3d/stdruby/fileutils.rb:1533: warning: already initialized constant FileUtils::Entry_::DIRECTORY_TERMĬ:/Program Files/SketchUp/SketchUp 2023/Tools/RubyStdLib/fileutils.rb:1567: warning: previous definition of DIRECTORY_TERM was hereĬ:/ProgramData/SketchUp/SketchUp 2023/SketchUp/Plugins/Trnsys3d/stdruby/fileutils.rb:1656: warning: already initialized constant FileUtils::LOW_METHODSĬ:/Program Files/SketchUp/SketchUp 2023/Tools/RubyStdLib/fileutils.rb:1686: warning: previous definition of LOW_METHODS was hereĬ:/ProgramData/SketchUp/SketchUp 2023/SketchUp/Plugins/Trnsys3d/stdruby/fileutils.rb:1662: warning: already initialized constant FileUtils::METHODSĬ:/Program Files/SketchUp/SketchUp 2023/Tools/RubyStdLib/fileutils. Artisan is an extension for SketchUp that lets you do the impossible With powerful tools for subdivision, sculpting, soft selection, free-form deformation. I think I can change the roof and ground to their proper surfaces however, in the long run, it would not be efficient. And installed the 2023 version of the TRNSYS3D plugin and I still have the same issue that the floor is shown in red, the roof in gray and the walls are inside out (The dark yellowish surface is inside). New in Artisan 2 is full compatibility with the QuadFace quad which is the defacto standard for handling non-planar quads in SketchUp.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |